Concrete Treatments - Protection - Clear Impregnants
Product Description
Sikagard 700S
|
Sikagard-700S is a single-pack solvent containing impregnation based on silane/siloxane with good penetrative properties. It forms a hydrophobic (water repellent) but water vapour permeable surface on mineral substrates. It Provides an hydrophobic surface layer which prevents the passage of moisture and hence water borne salts (chlorides) into concrete and thereby enhances durability.
Sikagard-700S is used for the impregnation for mineral substrates such as concrete and plaster surfaces, natural stone, aerated concrete, brick work and block-work, fibre cement, some mineral paint coats, Sika MonoTop mortars, etc. providing resistance against driving rain and dampness. Sikagard-700S is mainly used to protect building facades and exposed concrete or cementitious mortar surfaces against moisture ingress. |
Sikagard 703W
|
Sikaguard 703W is a liquid, ready for use, silane/siloxane based product used for the impregnation of concrete and masonry building facades. |
Sika Ferrogard-903
|
Sika FerroGard 903 is an amino-alcohol based corrosion-inhibiting aqueous impregnation for concrete. It penetrates the concrete and has an affinity with the surface of the reinforcement steel. Sika FerroGard 903 is used for the corrosion protection of steel reinforced concrete structures, above and below ground. It is also used during the repair and maintenance of reinforced concrete structures, as a treatment of reinforcing steel which is corroding, or is in danger of corroding, in areas without any visible concrete defects. |
BASF Masterseal 355
|
Masterseal 355 is a one component, transparent, penetrating silane/siloxane impregnant. The product reacts chemically with a mineral substrate to form a surface that is repellent to water yet still permeable to water vapour. Masterseal 355 protects and preserves the substrate without altering the natural surface texture or colour. Masterseal 355 is recommended for weatherproofing exterior building brickwork, concrete, cement rendered concrete blocks, natural or cast stone etc.s |
BASF MCI-2020 is a surface applied corrosion inhibitor designed to migrate through even the densest concrete structures and seek out the steel reinforcing bars. MCI-2020 also protects a multitude of other metals including carbon steel, galvanised steel and aluminium. The unique feature of Migrating Corrosion Inhibitors™ (MCI®) is that if not in direct contact with metals, the inhibitor will migrate for a considerable distance through concrete to provide protection. MCI-2020 will stop the further corrosion of.
reinforcing metals and extend the service life of the structure.
reinforcing metals and extend the service life of the structure.
Dribond Natural Sealer
|
Dribond Natural Sealer is a clear solvent based sealer that penetrates deep into concrete and masonry surfaces and hydrolyses in the pores and capillaries forming a weather and chemical barrier without changing appearance. It is used on concrete, bricks, stone and masonry surfaces to preserve its original appearance. Dribond Natural Sealer seals surface from moisture and protects surface from atmospheric chemical attack It will not darken or yellow with age and provides reduced weather staining - vertical surfaces tend to be self cleaning. It may be recoated at any time.. |
Dribond Damp Cure
|
Dribond Damp Cure is a siloxane/solvent based material that is injected into the masonry to form a new damp proofing course. DAMP CURE lines the masonry pores but does not actually block them entirely, allowing the masonry to “breathe” which facilitates rapid drying out of the affected masonry. Once cured, DAMP CURE causes a change in the interfacial tension (measured by the contact angle) between the capillary wall and the water preventing water entering the new barrier. It is used to provide a water impermeable damp course which is stable in highly alkaline conditions and does not weaken the building structure |